YOU WILL NEED THIS HARNESS IF YOUR BATTERIES ARE IN THE BACK CENTER NEAR THE TRANSOM OR BACK STARBOARD NEAR THE TRANSOM. Sea Clear Power 1726 Wiring Harness Sea Clear Power 1726 harness is mainly for Walleye boats that have the batteries in the back starboard side of the boat and the console is further towards the bow than the standard bass boat. It also works perfect for Tracker aluminum boats that don't have a rigging tube and require the harness to go down the side panel of the boat and into the transom with the steering cables. This harness has a 17-foot run to the console and a 26-foot run to the bow. The harness can be cut back to custom fit your boat. The first wiring harness ever made for the sole purpose of wiring up your Marine Electronics. Tired of poor image quality? Tired of your units blinking? Tired of your units and accessories for them not being on one system? Tired of waiting on your units taking 30 seconds to start reading structure scan after coming off the pad? Get with us today to solve all these problems with clean power and "sea" the difference. The Sea Clear Power Wiring 1726 Harness with Switch & Jumper is the first wiring harness ever made for the sole purpose of wiring up all of your marine electronics. Tired of poor image quality? Tired of your units blinking? Tired of your units and accessories not being on one system? Tired of waiting on your units taking 30 seconds to start reading structure scan after coming off pad? Pick up a Sea Clear Power Wiring Harness with Switch & Jumper today to solve all these problems with clean power and "sea" the difference. Compatible with all brands and accessories including Humminbird, Garmin, and Lowrance, the Sea Clear wiring system allows you to tie all of your graphs and electronics into one harness. You will need to purchase fuse holders to complete installation. Ttypically you will need one (1) fuse holder for every electronic device you add to the circuit. To get the highest performance, Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders, so every processor on your boat gets the clean and adequate power it needs to work properly. Check out the Sea Clear Power Wiring Harness with Switch & Jumper Install Walkthrough in the Product Video section for a full installation breakdown. Included: - 26-ft Universal Harness - Battery Disconnect Switch - 20-in Jumper Wire Please Note: You will need to purchase fuse holders to complete installation. Typically you will need one (1) fuse holder for every electronic device you add to the circuit. Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders to ensure clean and adequate power to all processors.
